I had a large pile of spoil and topsoil from the build of our pool and wanted to put in some seating and storage as well as a retaining wall. So I thought why not combine the lot!This was constructed using 4x2 and decking timber along with plywood sheeting, however it could be built from pallets (I just am too idle to dismantle that many pallets)
Firstly I had to dig out the area I wanted, this involved moving approx 12 cubic meters of sandysoil and clay. Unfortunately due to limited access this had to be done by hand and whellbarrow Fun!!
I made the frames ot of 4x2, initially I was going to have 4 seats but after looking at it it I decided that 6 would look better so 7 frames.
Each frame had 1x1200 mm, 1x650mm,1x570mm,1x520mm and 1x530mm which had 5 degree angles as shown for the seat back
Assemble the frames, I used 100mm nails (fine carpentry skills there!)
Put in position and brace, note that the "feet" of the frames are buried to give the required sturdiness for a retaining wall
Start panelling out with decking timber
18mm marine ply for seat base cut to fit and screwed in position
12mm ply for seat backs before backfilling screwed into place
Plastic sheet stapled to 12mm ply as rot barrier and backfilled
Arms/drink rests screwed from underneath ( I put in the cushion squabs and then cut the arms to fit to ensure snug fit) The squabs were boat squabs from a local yacht chandler
Access to storage cut out with oscillating saw/jigsaw hole in centre to assist removal
Corner supports screwed in place, I only put one access per 3 seats in but may decide to put more later
Uprights put on to conceal screws
And thats it done, just need to tidy the area in front (a little more digging) and am going to put a fire pit in them plant
Original article and pictures take http://www.hometalk.com/11159653/combined-garden-modular-seating-retaining-wall-storage site
Комментариев нет:
Отправить комментарий