среда, 24 мая 2017 г.

How to DIY A Feature Wall


A Feature Wall to enhance the look of your room is the perfect DIY project. See how I created one in my basement using baseboards!


Last winter I was all set to create a board and batten "feature wall" in the basement, this is the wall I chose. After measuring height and width and a rough idea of the pattern I liked I quickly realized the cost of recreating my favorite board and batten design was too costly for the basement. Being determined to figure out a better way I went to our local overstock building supply warehouse, Loading Dock South for ideas on making it more affordable.
Luckily I found they had just gotten a pallet of 5 " baseboards. They were close to 70% off retail. So with a rough estimate of the amount I needed, this was a steal!
My plan moved from traditional board and batten to four large "frames" using these beautiful baseboards.


how to diy a feature wall, diy, how to, wall decor, woodworking projects, Before




I measured and cut the boards to size using a miter saw. A table saw would have been a better idea for this size baseboards.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




I attached the baseboards to the wall using a pneumatic nail gun.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




I used the longest level I had, liquid adhesive and tape when a stud wasn't nearby.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




You might think this is the after photo, sadly it isn't. See the space between the frames at the top? I thought that looked unfinished so I decided to make three more smaller boards to connect them.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




Using the remnants of the baseboards I trimmed the decorative edge off with a jigsaw.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




Attached to wall with liquid adhesive.
Feeling like it was a little too plain, I added a few more pieces of trim to the smaller panels between the four large frames.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




With Gorilla Glue liquid adhesive and masking tape.


how to diy a feature wall, diy, how to, wall decor, woodworking projects




Tah-Dah! Well, not quite but sort of. I added a fresh coat of paint to the surrounding wall and soffit area, caulked every single piece of added trim and most importantly I added my own custom coffered/beadboard ceiling to the suspended ceiling and this is how it looks now!


how to diy a feature wall, diy, how to, wall decor, woodworking projects




Just to see if you were paying attention were you wondering-where did the door go??Hop over to my blog and I'll show where it went!
Thanks for checking it out,
Holly


how to diy a feature wall, diy, how to, wall decor, woodworking projects





Original article and pictures take http://www.hometalk.com/11025441/how-to-diy-a-feature-wall site


Комментариев нет:

Отправить комментарий